Grand National Aerocoupe PROJECT -  Page 2

Page 1  -  Page 2  -  Page 3  -  Page 4  - Page 5  -  Page 6  - Page 7 - Page 8

Here is the Monte's tail section clamped to the outside of the GN. You can see where I marked a line on the inside so I could cut off the overlapping metal. I want to butt the two pieces together and then weld them together making a seamless "factory" looking one piece rear panel. The panels still need to be tweaked a little and hammered out straight to get the bends and creases out.

This picture is after I cut the overlapping metal off. I now can place it on the inside of the GN's tail section.

Clamped on the inside....

 

Now for the pictures with the tail lights and quarter extensions! This REALLY made the rear look finished and "factory" looking! It looks like it's ready to install the trunk already!

The sheet metal still has to be tweaked and hammered out to get it straight.

 

Here is how everything lines up...